Categories

{{ selectedCategory.name }}

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!

How to connect iC5700 BlueBox and embedded target via Active Probe?

22-Dec-2022

The Active Probe is connected to the embedded target and the other side connects to the iC5700 FNet port via the FNet cable. 


Configuration steps:

1. Connect the grounding wire first.

Allocate ground potential (GND) on the embedded target and connect it with the GND pin on the BlueBox front panel with the grounding wire delivered along the BlueBox. 

It is very important for both, the BlueBox and the Target to have a common ground potential at the power on and power off procedure. Otherwise transient voltage spikes which can occur during the power On/Off procedure can damage the hardware.


2. Connect ribbon cable adapter(s) to embedded Target.
White dot is indicating pin one. Connectors also have a key and socket. Insert (and remove) the black connector parallel to the surface of the Target Board. 


3. Connect  Active Probe FNet port to the BlueBox FNet Port with enclosed FNet cable. 



More resources:

Was this answer helpful?

Sorry this article didn't answer your question, we'd love to hear how we can improve it.
Note: This form won't submit a case. We'll just use it to make this article better.

Similar topics

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No similar topics found!

Other topics in the same category

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!