Categories

{{ selectedCategory.name }}

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!

Setting debug interface voltage levels (Vref)

14-Mar-2024

The voltage levels for the debug interface are configured within winIDEA via CPU Options dialog.


Solution

Make sure Vref is selected for Debug I/O levels, otherwise, the debug session fails or may behave unpredictably.

1.  Open Hardware / CPU Options / Hardware.

2. Select the Vref option. 



The debugger also provides an option Check Vref on startup. The option is checked by default and results in the debugger checking the voltage automatically when establishing initial debug connection to the target CPU.


If the debugger can't connect to the CPU, double check that the CPU power supply voltage is present at the target LPD debug connector or JTAG/Nexus debug connector at the belonging pin. Either measure the voltage directly on the belonging debug connector pin with voltmeter or open the Measurement Plugin  (where available, e.g. iC5000, iC5700) by clicking View / Measurement and check the Vref value, which displays measured reference voltage by the BlueBox or use the Check Vref on startup option mentioned above.


winIDEA 9.17.182 and older: 

Vref option is located in Hardware / Emulation Options / Hardware


Was this answer helpful?

Sorry this article didn't answer your question, we'd love to hear how we can improve it.
Note: This form won't submit a case. We'll just use it to make this article better.

Similar topics

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No similar topics found!

Other topics in the same category

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!