Categories

{{ selectedCategory.name }}

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!

After firmware update debugger cannot connect to the target

03-Aug-2021

Bitstream programming failed and therefore the debugger does not respond.


Possible solution:

By selecting different CPU architecture a new bitstream will be loaded if the one programmed inside the  BlueBox debugger is faulty. Bitstream programming is done before the debugger connects to the target. 

1. Create a new workspace by clicking File / Workspace / New Workspace.

2. Select a different CPU architecture via Hardware / Emulation Options / CPU tab.

3. Perform a CPU reset. CPU reset will fail, but winIDEA will program a different bitstream that depends on the CPU architecture use.

4. Return to your original workspace, perform download and correct bitstream will be programmed.

Was this answer helpful?

Sorry this article didn't answer your question, we'd love to hear how we can improve it.
Note: This form won't submit a case. We'll just use it to make this article better.

Similar topics

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No similar topics found!

Other topics in the same category

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!