Categories

{{ selectedCategory.name }}

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!

NXP/ST Power Architecture / ST SPC58: Flash mass erase on HSM enabled device

09-Sep-2022

When Alternate Flash Programming Interface is set, only the HSM core has access to HSM code and data flash. Erased HSM code flash does not contain valid HSM boot headers, therefore HSM core remains in reset state forever, and flash monitor cannot be executed there. As a consequence the HSM functionality is not possible anymore, so HSM code flash must not be erased.


Possible solution: 

Use the script which mass erases all the flashes (code + data and HSM data flash) except the HSM code flash. Please contact iSYSTEM Support to get the script.

As a consequence the HSM functionality is not possible anymore, so the HSM code flash must not be erased. This does not apply when Main Flash Programming Interface is set - all flashes can be erased, unless HSM code/data flash are reserved by HSM_EXCLUSIVE DCF record.

Was this answer helpful?

Sorry this article didn't answer your question, we'd love to hear how we can improve it.
Note: This form won't submit a case. We'll just use it to make this article better.

Similar topics

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No similar topics found!

Other topics in the same category

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!