Categories

{{ selectedCategory.name }}

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!

NXP/ST Power Architecture: How to configure general CPU settings?

03-Aug-2021

These configuration steps are required to connect iSYSTEM BlueBox to the Target and perform CPU Reset command, which establishes initial Debug connection.


Solution:

1. Select your Device in a new Workspace

2. Configure JTAG settings.

3. Password protection.

Certain MPC5xxx/SPC5x devices provide a 64-bit or 256-bit password for debug interface protection to prevent unauthorized access to the on-chip debugging resources.  

Use the debug interface protection with caution since the device can unintentionally become inaccessible.


More resources:

Was this answer helpful?

Sorry this article didn't answer your question, we'd love to hear how we can improve it.
Note: This form won't submit a case. We'll just use it to make this article better.

Similar topics

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No similar topics found!

Other topics in the same category

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!